EINBREW.COM
EINBREW 1V1P USER INSTRUCTIONS
V1.0.6 © ACKSEN LTD 2017
17
Control Section
Explanation
Vessel
Displays the Set Temperature on the top half of the display, and the
Measured Temperature on the bottom half. The Up/Down buttons will
allow you to increment and decrement the presently displayed set
temperature. The temperature displayed will depend on the active
Stage/Phase.
The Green indicator will be lit when the system is running and the heater
has been turned on.
Any changes made will be automatically remembered.
Here you can set the Pre-Heat, Mash, Boil and Cooling temperatures.
Switch between these with the
Select
button.
When the Pre-Heat stage is active, you can set the Pre-Heat/Mash In
temperature.
When the Mash Stage is
active
, the display shows the Set Temperature for
the presently selected Mash Phase on the top half of the display, and the
Measured Temperature on the bottom half. The present Mash Phase time
will be displayed on the bottom half of the
Timer
display (Ph 1 to Ph 9) and
can be adjusted there.
The Up/Down buttons will allow you to increment and decrement the
presently displayed set temperature.
To switch between the different Mash Phase timings, press the
Set
button.
The display will go through Mash Phase 1 to Mash Phase 9, and back to
Mash Phase 1 each time
Set
is pressed. If you don’t want to use a
particular Mash Phase, set the time for the Phase to be OFF (go to 0
minutes, then press Down again so the display changes to OFF). Please
note that Mash Phases set to 0 minutes will change the set temperature
for the brew accordingly when they’re triggered, but will not run for any
time when the set temperature is met.
When the Boil Stage is
active
, the display shows the Set Temperature for
Boil on the top half of the display, and the Measured Temperature on the
bottom half.
To switch between the different Hop Insertion timings, when the BK stage
is active, press the
Phase
button. The display will go through Hop
Insertion 1 to Hop Insertion 9 on the bottom half of the timer display
above (HOP1 to HOP9), and go back around to Boil set temperature, each
time
Phase
is pressed. If you don’t want to trigger a particular hop
insertion, set the time to be OFF (go to 0 minutes, then press Down again
so the display changes to OFF). Please note that Hop Insertions set to 0
minutes will be triggered immediately as the Boil stage starts.
