14
TIP:
if there are other radio-frequency transmitters in the same coverage area where the WCS1000
system is used, we suggest to turn them on when setting the RF channels using auto-scan, so the
system will choose frequencies that are truly free.
IMPORTANT NOTE
: the transmitting channels are set on the receiver unit only. The WCS1000RX
manages the RF channels and tell to the chairman and delegate units which RF channel they have
to use. To do that WCS1000RXV2 uses the room control channel and this is
why it’s so important
that the room control channel is the same for all units. See above about how to set the room
control channel on WCS1000RXV2, further in the manual you can see how to set it on transmitter
units.
WCS1000CV2 and WCS1000DV2 INSTALL OR REPLACE THE BATTERY PACK
When the display on WCS1000CV2 or WCS1000DV2 units shows a low battery level or when the battery pack
is completely exhausted, replace the battery pack as follows:
IMPORTANT:
be careful to respect always the polarity marked inside the battery inlet.
Remove the batteries if you don’t use the microphone for a
long period of time: this will avoid the
corrosion of the battery contacts.
WCS1000CV2 and WCS1000DV2 MICROPHONE INSTALLATION
To install the microphone gooseneck into the base, insert it to the base connector, then turn it until it slides
slightly into the connector. When it is inserted completely (be careful to not force it!), screw the security ring
clockwise:
To remove the gooseneck unscrew the security ring before disconnecting.
Summary of Contents for WCS1000
Page 1: ...WCS1000 WIRELESS CONFERENCE SYSTEM USER S MANUAL ENGLISH ITALIANO 96MAN00107 REV 1 0 17...
Page 37: ...37 FIG 1 FIG 2...
Page 38: ...38 FIG 3 FIG 4...
Page 39: ...39...
