16
CONFERENCE SYSTEM AUDIO CHECK
If you had followed all previous set-up instructions, your conference system should be set to operate
properly. At this point finally you have to check the audio system following these instructions.
Connect the receiver WCS1000RXV2 to the
conference room’s audio system.
Set the level controls of your audio system at mid position or “0” level
.
Then turn on the WCS1000RXV2 receiver and set all the level knobs to minimum.
Press the talk button on the transmitter unit and speak loudly at the microphone.
Set the VOL level using the buttons on the transmitter unit
Meanwhile check the optimal level on the LED bar:
all LED light except the PEAK LED
.
Typically the VOL bar on the transmitter display should be placed in the ¼ to ¾ range.
Finally raise up the VOL knob on the WCS1000RXV2 receiver and set the volume to an
audible e comfortable level, avoiding feedback noise. Typically the knob should be stay in
the ½ to ¾ range.
Repeat this procedure for each transmitter and finally check the whole system with the maximum number of
5 microphone active: if there is any audio feedback, reduce the main level of the audio system.
WCS1000RXV2 LOCK & UNLOCK
After the system is set-up properly, it could be useful to lock all the buttons on the receiver in order to avoid
inappropriate operation from unauthorized person.
LOCKING
: Press and hold the SET button first, then press
UP button, the display will show:
UNLOCKING
: Press and hold the SET button first, then press
DOWN button, the display will show:
Summary of Contents for WCS1000
Page 1: ...WCS1000 WIRELESS CONFERENCE SYSTEM USER S MANUAL ENGLISH ITALIANO 96MAN00107 REV 1 0 17...
Page 37: ...37 FIG 1 FIG 2...
Page 38: ...38 FIG 3 FIG 4...
Page 39: ...39...
