ALWAYS TURN OFF THE POWER SUPPLY FROM MAIN CIRCUIT BREAKER FIRST!
1. REMOVE THE LENS FROM THE HOUSING NEAR ONE END OF THE HOUSING BY USING THE PROVIDED SUCTION
CUP. PRESS THE SUCTION CUP TO ABSORB ONE SIDE OF THE LENS, PULL THE SUCTION CUP TO DETACH THE
LENS FROM THE LUMINAIRE HOUSING (FIG. 1).
2. USE A SCREWDRIVER TO PUNCH OUT ONE OF THE KNOCKED HOLES AND PASS THE ELECTRICAL CABLE OUT
FROM THE HOUSING.
3. USE THE LUMINAIRE AS A TEMPLATE BY PLACING IT ON THE JUNCTION BOX AND PENCILING IN THE CEILING
THE FOUR HOLES POSITIONS. PUT THE LUMINAIRE ASIDE AND DRILL THE FOUR HOLES. INSERT AN ANCHORING
BOLT (NOT INCLUDED) INTO EACH HOLE. SCREW THE FOUR MOUNTING SCREWS INTO EACH ANCHORING
BOLT,THEN CONNECT THE AC WIRES (FIG. 2).
4. INSTALL THE LENS STARTING AT ONE END OF HOUSING. INSERT LENS SLOT ONTO EDGE OF HOUSING.
CAREFULLY SQUEEZE THE LENS TO ENGAGE OPPOSITE SIDE WITH HOUSING. CONTINUE THIS ACTION DOWN
LENGTH OF LENS UNTIL FULLY INSTALLED ONTO HOUSING (FIG. 2).
5. TURN ON THE FIXTURE.
SURFACE MOUNT (A) INSTALLATION:
SURFACE MOUNT (B) INSTALLATION:
1. REMOVE THE LENS FROM THE HOUSING NEAR ONE END OF THE HOUSING BY USING THE PROVIDED SUCTION
CUP. PRESS THE SUCTION CUP TO ABSORB ONE SIDE OF THE LENS, PULL THE SUCTION CUP TO DETACH THE
LENS FROM THE LUMINAIRE HOUSING.
2. USE A SCREWDRIVER TO PUNCH OUT ONE OF THE KNOCKED HOLES AND PASS THE ELECTRICAL CABLE OUT
FROM THE HOUSING.
LENS
HOUSING
REMOVE
HOUSING
SUCTION CUP
PRESS
LENS
PULL
LENS
JUNCTION BOX
PRESS
CEILING
ANCHORS
MOUNTING
SCREWS
HOUSING
PLACE
PRESS
PRESS
PRESS
1
2
DIFFUSER
HOUSING
PRESS
PRESS
PRESS
PLACE
ANCHORS
MOUNTING SCREWS
J-BOX
PLACE
SLIDE
INSTALL DIFFUSER
