Optical adjustment
- 69 -
(1) Focus Adjustment of LCD Panel
Before Adjustment :
1. Turn on a projector.
2. Set the projector to "service mode" and project a green grid pattern on a screen. Adjust green grid pattern
to sharp focus by pressing Focus (
)(
) buttons on the projector or remote control unit.
3. Press Zoom(
)(
) buttons on the projector or remote control unit. When focus is changed at minimum
Zoom and maximum Zoom, following adjustment is necessary.
Adjustment :
1. Loosen 4 screws-A using ball allen wrench.
2. Set image size to the minimum, pressing Zoom (
) button on the projector or remote control unit.
3. Adjust center part of green grid pattern to sharp focus, pressing Focus (
)(
) buttons on the projector or
remote control unit.
4. Set image size to the maximum, pressing Zoom (
) button on the projector or remote control unit.
5. Insert a slot screwdriver into slot-B, turn it and adjust center part and four corners on the green grid pattern
to sharp focus.
6. Repeat steps 2 to 5. Until focus does not shift by the ZOOM position between TELE and WIDE.
7. Tighten 4 screws-A to fix the assembly LCD panel / prism using ball allen wrench.
SCREW-A
SCREW-A
SCREW-A
SCREW-A
SLOT-B
Prism / LCD Panel
assembly
1
1
2
5
5
2
3
3
4
4
Minimum zoom (TELE)
Maximum zoom (WIDE)
Fig.53a
Fig.53b
Summary of Contents for LC-XT4E
Page 103: ...103 IC Block Diagrams CXA2151Q RGB Matrix IC2261 CXD2064Q 3 Line Y C Separator IC2101...
Page 106: ...106 IC Block Diagrams Sii169ACT DVI Interface IC8001 PW365 Scan Converter IC301...
Page 159: ...159 MEMO...
Page 160: ...LC XT4U E APR 2006 2006 Eiki International Inc A key to better communications...
