Eiki LC-XlU, Owner'S Instruction Manual, Page: 9 / 52

CONNECTING THE PROJECTOR
CONNECTING THE COMPUTER
CONNECTING TO THE COMPUTER IN PUT 1 JACKS (BNC TYPE x 5)
Personal computers can be connected to the computer input (Red, Green, Blue, Horiz. Sync. and Vert. Sync.) on the
projector.
• Connect the computer to these jacks using the BNC cables (not provided).
CONNECTING TO THE COMPUTER INPUT 2 TERMINAL {HDB15-PIN (VGA)}
Personal computers can be connected to the HDB1 5-pin (VGA) terminal on the projector.
• Connect the computer to these terminals
using the VGA cable or VGA cable with VGA/MAC adapter
(provided).
WARNING:
For
projectors, the VGA cable provided is
designed to reduce RFI (Radio Frequency Interference)
emissions. For regulatory compliance reasons, this cable must be used and must not be replaced by any
other cable.
CONNECTING TO THE COMPUTER AUDIO INPUT JACKS (1 and 2)
• Connect audio outputs from your computer to these jacks using the RCA cable (not provided).
• If
the audio input of the audio equipment is stereo, be sure to connect the right and left channels to the respective
right and left jacks.
• If the audio input of the audio equipment is monaural, connect it to the left jack.
CONNECTING TO THE MULTI-POLE 12-PIN (CONTROL PORT) CONNECTORS (1 and 2
)
• When the computer is operated by the remote control unit, connect three different type of cables (provided) between control
port and computer mouse port or serial port.
CONNECTING TO THE MONITOR OUTPUT TERMINAL {HDB15-PIN (VGA)}
This terminal contains the information that is viewed on the screen.
An external monitor can be connected to the HDB1 5-pin (VGA) terminal on the projector.
• Connect the monitor to
this terminal using the VGA cable (not provided).