USING THE PROJECTOR
TO
TURN ON THE PROJECTOR
Connect the projector to a video source (Computer, VCR, Video Camera, Video Disc Player, etc.) using the
appropriate terminals on the side of the projector (See “CONNECTING THE PROJECTOR” section on pages 9-16).
Connect the projector’s AC power cord into a wall outlet and turn the MAIN ON/OFF switch (located on the side of
the projector) to the ON position. The LAMP POWER indicator will light RED, the READY indicator will light GREEN.
Press the LAMP POWER ON/OFF button on the remote control unit or on the
projector to ON. The LAMP POWER indicator light will dim and the cooling fans
will
operate. The count-down display appears on the screen and the count-down starts
(30-29-28-...1). The signal from the video source appears after 30 seconds.
CAUTION:
THIS PROJECTOR USES A METAL-HALIDE ARC LAMP. TO
EXTEND THE LIFE OF THE LAMP, ONCE YOU HAVE TURNED
IT ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.
NOTE
: TEMPERATURE WARNING INDICATOR flashes red, the projector will automatically turn off.
Wait at least 5 minutes before turning the projector on.
If
the TEMPERATURE WARNING INDICATOR continues to flash, follow the procedures below:
(1). Press LAMP POWER ON/OFF button to OFF.
(2). Check the air filter for dust accumulation.
(3). Remove dust with vacuum cleaner (See “AIR FILTER CARE AND CLEANING” section on page 48.)
(4). Press LAMP POWER ON/OFF button to ON.
If the TEMPERATURE WARNING INDICATOR still continues to flash, call your authorized dealer or service
station.
TO TURN OFF THE PROJECTOR
Press the LAMP POWER ON/OFF button on the remote control unit or on the
projector. The “Power off
?“
appears on the screen. Press again the LAMP POWER
ON/OFF button to turn OFF the projector. The LAMP POWER indicator will light bright
and READY indicator will turn off. The cooling fans will operate for 1 minute after the
projector is turned off. (During this “cooling down” period, the projector cannot be
turned on.) The READY indicator will light green again and the projector may be turned
on by
pressing the LAMP POWER ON/OFF button. To power down completely,
turn the MAIN
ON/OFF switch (located on the side of the projector) to the OFF
position.
DIRECT OPERATION
MODE SELECT
Press the MODE button (located on remote control unit or on the projector) to select
Computer 1, Computer 2, Video 1 or Video 2 Input. The “Computer 1”, “Computer 2”,
“Video 1” or “Video 2” display will appear on the screen for a few seconds.
Summary of Contents for LC-XlU
Page 1: ...MULTIMEDIA PROJECTOR MODEL LC XlU OWNER S INSTRUCTION MANUAL ...
Page 17: ...OPERATION OF CONTROLS ...
Page 27: ......