52
Setting
Standby mode
This function is available when operating the
projector via network.
Network
.. Supply the power to the network
function even after turning off the
projector by pressing the ON/
STAND-BY button on the remote
control. You can turn on/off the
projector via network, modify
network environment, and receive
an e-mail about projector status
while the projector is powered off.
Eco
......... Select
Eco
when you do not use
the projector via network. The
projector’s network function will
stop when turning off the projector.
Refer to the owner’s manual of “Network Set-
up and Operation”.
Note:
When selecting
Network
, the cooling fans may
be running depending on the temperature inside
the projector even if the projector is turned off.
This function allows you to change the setting of
the P-timer and execute it.
Select one of the following options:
Count up
....... The P-timer display
000:00
appears on the screen and the
count up starts (
000:00-180:00
)
Count down
.. The time set in the Timer setting
appears on the screen and the
countdown starts.
Timer
............. Use the Point
▲▼
buttons to set
the Timer (
1-180 Min
).
Timer
is
available in Count down only.
Factory default value is
10 Min
.
Start
............... It executes
the count up or
count down function. Press the
SELECT button at
Start
and the
indication changes into Stop.
To stop
Count up
or
Count
down
, press the SELECT button
at
Stop
on the screen menu,
then the indication changes into
Restart
. Press the SELECT
button at
Restart
to resume
Count up
or
Count down
.
Reset
............. Reset the P-timer values.
Press the SELECT button at
Reset
to return to the following value:
Count up
........ "000:00"
Count down
... Timer that
you set
Exit
................ To exit the P-timer operation.
P-TIMER
P-timer display
Stop or Cancel the P-timer via Remote control
To stop the P-timer function, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER
button for a few seconds.
P-timer
X: disabled O: enabled
*1 When
Eco
is selected, it is only possible to turn on the
projector while using the RS-232C serial port.
*2 When switch the Standby MIC out function On and in
Standby mode status, only MIC volume can be output.
Monitor Out
Audio Out
Direct on
Serial command
Network
*2
*1
