Eico PHANTOM PREMIUM 80 N A, Instruction On Mounting And Use Manual, Page: 71 / 220

FUNZIONAMENTO I
71
OPERATION
71
GB
TROUBLESHOOTING
Attention
If you see a crack in the glass top (however small), switch off the hob immediately and disconnect it
from the power mains. Contact the service department.
If the appliance does not work properly, this does not always mean that it is defective. Try to deal with
the problem yourself first by checking the table below. You can also take a look on our website for more
information. If the problem continues, contact the service department.
Symptom Possible cause Solution
The display lights up when the
hob is activated for the first
time.
This is the standard set-up
routine.
Normal operation.
The fan runs on for several
minutes after the hob has been
switched off.
The hob is cooling. Normal operation.
A slight smell is noticeable the
first few times the hob is used.
The new appliance is heating
up.
This is normal and will
disappear once it has been
used a few times. Ventilate the
kitchen.
The pans make a noise while
cooking.
This is caused by the energy
flowing from the hob to the
saucepan.
At high levels this is perfectly
normal for some pans. It will
not damage either the pans or
the hob.
You have switched on a
cooking zone, but the display
shows u .
The pan you are using is not
suitable for induction cooking,
or has a to small diameter.
Use a suitable pan.
A cooking zone suddenly stops
working and you hear a signal.
The time that has been set for
the timer has ended.
Touch the left or right timer key
to stop the alarm.
The hob is not working and
nothing appears in the display.
There is no power supply due
to a defective cable or a faulty
connection.
Check the fuses or the electric
switch (if there is no plug).
A fuse blows as soon as the
hob is switched on.
The hob has been wrongly
connected.
Contact a professional installer.
L shows on the display. Child safety lock is activated. See chapter ‘Operation of the
hob/Child safety lock’.
Error code ER 03. You have pressed two or more
keys at the same time.
Do not operate more than one
key at the same time.
The control panel is dirty or has
water lying on it.
Clean the control panel.