7
1
-800-497-4524 EIC SOLUTIONS, INC
.
215-443-5190
5.
Install the rest of the screws in the flange placing a nylon washer on each fastener and
screw them into the tapped holes in the enclosure. Do not tighten them completely.
a.
If you have purchased a vertical drip pan, you will need to install the three long
screws in the three center holes in the bottom flange.
6.
Remove the two starter screws and place a nylon washer on each and reinstall.
7.
Tighten all screws.
INSTALL THE DRIP PAN
1.
Two hose fittings were provided with the drip pan, a right angle and a straight one. Choose
one and install it on the drip pan. Be sure if you use the right angle fitting it is facing the
desired direction prior to installing the drip pan.
2.
There are three mounting holes in the drip pan, match these with the long mounting screws
protruding into the enclosure at the bottom of the AC unit. Push the drip pan onto these
screws.
3.
Using the three 8-32 keps nuts provided, attach the drip pan to the air conditioner.
4.
Attach the supplied PVC drain tube to the hose fitting on the drip pan. This tube should be
routed to the bottom of the enclosure and fed through a 3/8” hole to the outside.
5.
If you purchased a horizontal drip pan, it is installed at the factory and you will only need to
install the hose fitting and PVC drain hose.
YOU MUST USE THE FACTORY INSTALLED HORIZONTAL DRIP PAN IF YOU INSTALL THE AIR
CONDITIONER HORIZONTALLY (FIG 2.2) ON THE TOP OF YOUR ENCLOSURE. FAILURE TO DO SO
MAY ALLOW CONDENSATE TO DRIP IN AN UNCONTROLLED MANNER CAUSING DAMAGE TO YOUR
EQUIPMENT.
APPLY POWER
Once the air conditioner is mounted, check the serial label and confirm the voltage required
and then apply appropriate power as outlined below.
120 VAC units – plug into standard 120 volt, grounded outlet. Amperage for a 120 VAC unit is
9.4 amps.
220 – 240 VAC units – this unit will not have a plug on the end. Connect the wires to an
appropriate power source using standard safe wiring methods. Wire colors are as follows:
Black or Brown – line
White or Blue – line/neutral
Green or Green/Yellow – ground
A wiring diagram is shown in Fig. 2.4. Amperage for a 220 VAC unit is 6.9 amps.
