15
General Instructions
The machine may be used only completely installed with the intended
transport or tilting trolley.
Use only stirring rods recommended by the manufacturer.
Thread and front surfaces must be kept clean.
Safety Instructions
Safe work with the machine is only possible, if you read
this operating instructions completely and strictly follow
the instructions contained herein.
In addition, the general safety instructions in the
enclosed brochure have to be observed. Take part in a
practical introduction before the first use.
If the connecting cable is getting damaged or cut during the
work, don’t touch it, but instantly pull the plug out of the
socket. Never use the machine with damaged connecting
cable.
The machine must neither be wet, nor be used in humid
ambient conditions.
Do not use the tool for mixing materials either in danger of explosion
(petrol, diluent).
Modifications of the tool are prohibited.
Always check the tool, cable and plug before use. Have damages only
repaired by specialists. Only insert the plug into the socket when the
tool switch is OFF.
Ensure a safe state of the machine.
When the machine runs outside, always use a protection switch
(30 mA max.) against fault current.
The machine should only run under supervision of somebody.
Pull the plug and switch the machine off if it is not under supervision,
e.g. in case of setting up and stripping down the machine, in case of
voltage drop or when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. This way, you
avoid that it starts suddenly and not under supervision.
Always lead the cable to the back, away from the machine.
Do not use the machine if a part of the housing is damaged or in case
of damages on the switch, the connecting cable or plug.
Power tools have to be inspected by a specialist in regular intervals.
Do not touch rotating parts.
Be careful with long hair.
Only work with close-fitting clothes.
Persons under 16 years of age are not allowed to use the machine.
Summary of Contents for TwinMix 1800
Page 3: ...3 7 6 3 2 1 8 10 9 5 4 ...