22
particles as well as non-flammable liquids, wood dusts and toxic dusts with
workplace exposure limits < 0.1 mg/m³.
Commissioning
Switch the unit ON/OFF with the switch (2a) in the top
section (1) (or switch to automatic mode — see Section operating field).
Operating field
Depending on the unit configuration, the following functions and settings are
available:
0 = Suction unit >off<
I = Suction unit >on<
IR = Vacuum cleaner switched on with automatic shaker function
AR = Vacuum cleaner on standby - The vacuum cleaner only
switches on when the tool is switched on. After the tool is
switched off, the vacuum cleaner runs on for approx. 10 sec to
prevent any residue from collecting in the hose.
The power socket (2b) is available for connecting an electrical tool.
Caution!
The electrical tool must be switched off during connection. The
power socket is permanently supplied with voltage when the plug is in the
mains socket regardless of the switch setting. In switch setting "0" the power
socket could still be used as an extension cable (e.g. for lights).
Connected load: Suction unit and connected unit max. 16 A.
Pre-selection switch (2d) for minimum volume signal (horn and light)
for suction units of the class "H".
In mode IR or AR, the following settings should be made depending on the
diameter of the hose:
Hose diameter
Switch setting
Ø 35 mm
70 m
3
/h
Ø 27 mm
40 m
3
/h
Ø 21 mm
20 m
3
/h
The speed is not regulated. The suction unit always runs at max. speed.
Operation (wet and dry suctioning)
When the handle pipe is used, the secondary air valve can be used to adjust
the suction output.
Pull out the plug after you have finished. Fix the suction hose in the
accessory storage location on the back of the container for storage. The
