4. INSTALLING YOUR CARBON MONOXIDE ALARM
INSTALLATION PROCEDURE
1. Select a suitable location based on the above advice.
2. Remove the CO Alarm from the mounting plate, as shown in figure 5, by holding the plate and sliding
the unit in the direction shown.
3. Connect the battery firmly to the battery snaps (see figure 6). The green, red and amber lights will
flash in sequence. (Note the red light may also flash intermittently for the first 70 seconds – this
is normal).
4. Carefully align the mounting plate to the wall or ceiling selected. Mark the position of the
two mounting holes using the mounting plate as a template. Drill two holes with a 5mm
drill for the plastic plugs supplied (See figure 7)
(Caution: Ensure there is no wiring where the screws are being installed).
5. Slide CO Alarm on to the mounting plate.
(Note: The unit may be tamper proofed further by removing the knockout on the sidewall of the
mounting plate as shown in figure 8 and inserting the self tapping screw (3mm diameter, 12mm long)
after the unit is on the mounting plate).
5. TESTING YOUR CO ALARM
13
B16204-R0-206D-UC-ENG 20/6/08 3:49 PM Page 15
