Ehrgeiz Fusion FS-80 RGBW/1, Operating Manual

Page: 46 / 62

13
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
Mode 1: 3 Channels
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
Mode 2: 4 Channels
Mode 3: 7 Channels
1 1 1 1 1 1 1 1 1 1 2
Mode 4: 8 Channels
1 2 1 2 1 2 1 2 1 2 1 2 1 2 1 2 1 2 1 2
Mode 5: 8 Channels
1 1 1 1 1 2 2 2 2 2 3 3 3 3 3 4 4 4 4 4
Mode 6: 16 Channels
1 1 1 1 2 2 2 2 3 3 3 3 4 4 4 4 5 5 5
Mode 7: 20 Channels
1 1 2 2 3 3 4 4 5 5 6 6 7 7 8 8 9 9 10 10 Mode 8: 40 Channels
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Mode 9: 80 Channels
Special Program Mode
2 2 2 2 2 2 2 2 2
5
3.2.2. Master mode
The master mode has to be set up like described above. It
works in the automatic program, the music control or in the
manual control. It’s important to make sure that the other
plugged units are working in the slave mode, and that there is
only one master unit in the line.
3.2.3. Slave mode
In this mode the unit reacts congruent to the master unit. If you
have plugged a few units into one line and connected them by
using a DMX cable, you are able to make one unit to be the
master. In this unit you can change your settings, and all other
units in the slave mode will follow you master instructions.
To set up the slave mode go to the DMX Addressing and push
down the mode until you reach SLAVE MODE. Press ENTER
to confirm.
3.3. Automatic program
- Press the UP or DOWN button until AUTOMATIC MODE
appears in the display.
- Confirm with ENTER to enter the submenu