11
4 PCS and Battery Cabinet Wall-Mounting Instructions
1.
Mount the wall bracket to the wall. Use the available slot
pattern to mount to a load-bearing structure rated for the
weight of the final system. The slots accommodate a M8
(5/16”) bolt diameter.
IMPORTANT!
Wall-stud mounting: A minimum of
three wall studs spanned within the width of the
mounting bracket are required. A minimum of two
mounting bolts are required per stud (top/bottom).
2.
(not shown) Remove the battery cabinet from the
packaging, and stand the cabinet upright. Remove the
front cover.
3.
Mount the two leveling brackets to the back side of the
cabinet. Each side of the cabinet must have a rubber
washer in direct contact with the cabinet wall.
4.
Lift the battery cabinet onto the wall mount bracket,
aligning the wall hooks at the rear of the cabinet with the
slots on the load-bearing face of the bracket.
5.
Slide the battery cabinet towards the right end of the
bracket to allow for clearance for the PCS cabinet.
6.
From the rear side of the cabinet, adjust the outer wingnuts
on the levelling brackets until the cabinet is vertically plumb
(level) to the wall.
1
3
4
3
9
8
6
Figure 7: Installation instructions.
Summary of Contents for Evolve LFP AU - 14 kWh
Page 43: ...38 INSTALLATION NOTES...
