EGSW
Environmental Group Southwest
8
The Bubbler
Installation and Operation Manual
INSTALLATION
Install the Diffuser:
• Thread one end of the air hose into the 1/4"galvanized
tting coming out from the diffuser plate.
• Attach the air hose to the chain using the provided
(6) zip ties to prevent slack (approx. every 5ft.).
* Trim zip ties
•
Invader:
Lower the unit onto the oor of the wet well.
*
Ensure that the diffuser is stabilized
without interfering with pumps and/or other
equipment.
Slim:
Lower the unit to the oor then raise the unit to
hang 2-4” above the oor.
*
Installation is recommended in the near
proximity to oat bulbs or any device used to
control operation of pumps.
• Tie off or secure the chain once you have stabilized
the suspended diffuser in the desired location.
• Route the air hose from the point where it exits the
wet well to the compressor.
• Remove the quick connect, cut the hose to the correct
length, and secure with worm-gear clamp. Re-install
the quick connect.
• Connect the air hose to the compressor using the
quick connect.
Connect Compressor to Diffuser
:
Summary of Contents for THE BUBBLER
Page 2: ...EGSW Environmental Group Southwest Water is Life www egsw us...
Page 14: ......
