CENTRE PUNCH AND DRILL Ø5MM HOLES AT THE PREVIOUSLY MARKED POSITIONS.
TRIAL FIT BOTTOM HINGES ON THE HEADER RAIL, ALIGNING THEM WITH THE PREVIOUSLY MARKED POSITIONS.
MARK THE THREE (3) HOLE POSITIONS OF EACH HINGE AND REMOVE THEM FROM THE VEHICLE.
FIG. 16
FIG. 15
FIG. 14
FIG. 13
REMOVE MASKING TAPE AND APPLY RUST INHIBITOR TO DRILLED HOLES.
TC0194
MITSUBISHI L200 3 PIECE TONNEAU COVER
17/11/09
Page 7 of 13
1
ALIGN HINGE
WITH PREVIOUSLY
MARKED POSITION
MARK THREE (3)
HOLE POSITIONS
x2
11
2
11
Ø5mm
20mm
CENTRE PUNCH,
THEN DRILL Ø5MM
HOLES (x6)
APPLY RUST
INHIBITOR
REMOVE
MASKING
TAPE
1
2
22
APPLY SILICON TO THE UNDERSIDE OF THE BOTTOM HINGES AND POSITION THEM ON THE HEADER RAIL.
2
11
11
11
1
NOT SUPPLIED
