FENDER FLARES INSTALLATION INSTRUCTIONS
FF935
24/05/19
Page 7 of 7
FOR THE RHS REAR FENDER FLARE
INSTALLATION REPEAT STEPS 22 TO 33
Attach the front part of the rear fender flare with (3) Hex
head screws and Speed nuts as per front fender process.
Reuse one factory plastic scrivet as shown.
29
LHS SHOWN
33
LHS SHOWN
31
Ensure that flares are aligned. Remove the tape liner.
Apply firm pressure on the flare to ensure the tape is
contacting the vehicle surface around the full perimeter of
the flares.
+
+
32
Fit the Mud Flap to the Fender Flare and secure with (3)
6mm plastic scrivets and one 10mm scrivet at the bottom,
with one 5mm spacer.
Fit the Mud Flap to the Fender Flare aligning with all the
holes. Mark and drill a 10.5mm hole in the liner for the
bottom scrivet as shown.
10mm
Ø10.5mm
12
7
8
9
x1
Attach the rear part of the rear fender flare with (3) Hex
head screws and factory plastic nuts. Secure the rear lower
part with one hex head screw and Speed nuts as shown.
30
LHS SHOWN
+
7
7
7
9
+
14
15
8
SPEED NUT
FENDER
