FENDER FLARES INSTALLATION INSTRUCTIONS
FF935
24/05/19
Page 4 of 7
On the inside of the bumper flare remove approximately
25mm of the protective liner from the double sided tape
locations. Fold the liner over and secure with masking tape
to the outside of the fender flare.
18
INSTALL
13
Follow the wiring harness that supports Active park assist
sensor up to the edge clip located under the driving lamp
assembly – dislodge the edge clip from the bumper & leave
off permanently.
14
Pull extra harness length gently through the OEM hole in
the bumper & refit in the Active park assist sensor; leave
loosely ready to fit to the fender flare.
FRONT
QUARTER FLARE
DRIVING LIGHT
HOUSING
DISLODGE CLIP
15
Fit inner (2) & outer (1) escutcheon for the Active park
assist sensor to the fender flare assembly.
16
Hold fender flare assembly close to the bumper & fit Active
park assist sensor to the escutcheon as per the Ford Work-
shop Manual (note the audible ‘click’ when the sensor is
fully home). Skip to step 18.
2
1
VIEW INSIDE THE FENDER
17
18
19
Fit the sensor cap and retaining strap to the fender flare,
and secure with the starlock washer.
17
SECTION VIEW
SECTION VIEW
