On the inside of the fender flare remove approximately
25mm of the protective liner from the double sided tape
locations. Fold the liner over and secure with masking tape
to the outside of the bumper flare.
Fit the fender flare to the vehicle in the uppermost vertical
position, before final fixings and tape application is com-
pleted as shown.
26
LHS SHOWN
LHS SHOWN
27
28
10mm
Ø8mm
FENDER FLARES INSTALLATION INSTRUCTIONS
FF935
24/05/19
Page 6 of 7
23
24
LHS SHOWN
LHS SHOWN
MUD FLAP
Remove the rear mud flaps by removing and retaining the
(2) screws and (2) scrivets from inside the wheel arch
as shown.
Remove the (3) scrivets from inside the rear wheel arch
as shown.
(x3)
(x1)
(x1)
(x2)
Rust
Inhibitor
25
LHS SHOWN
10mm
Ø8mm
Carefully drill through centre of rivet holding the liner behind
the rear mud flap, with a Ø8mm drill bit & and 10mm drill
stop as shown. Carefully remove the reminder of the rivet
using needle nose pliers. Apply rust inhibitor to the holes.
Carefully drill through centre of rivet holding the liner with a
Ø8mm drill bit & and 10mm drill stop as shown. Carefully
remove the reminder of the rivet using needle nose pliers.
Apply rust inhibitor to the holes.
Rust
Inhibitor
