2.7 Manual Network Configuration
An ethernet connection needs to be established, in order to
configure Querx. This initial connection is normally
configured automatically, which will let you access the device
as described in chapter 3.1
Accessing the Web Interface
. The
network connection will need to be configured manually, if
your network does not support DHCP, or if the computer you
wish to use for the configuration does not support mDNS.
⚠
Information
The steps detailed in the following section are not needed
by most users. Please continue reading at chapter 3
Web
Interface and Configuration Area
and chapter 4
Basic
Configuration
.
2.7.1 Installing the Device Discoverer
The
Device Discoverer
application can be found on the CD-
ROM included in the package. It can also be downloaded
from
sensors.egnite.de
.
The application will help you set up
Querx.
1.
Open the
Device Discoverer
installation file.
2.
Follow the install wizard’s instructions.
2.7.2 Configuring the Network Connection
1.
Start the
Device Discoverer
.
First Use
14
