Egholm Park Ranger 2150, Operator'S Manual, Page: 46 / 68

46
1
1
2
3
4
1
Operator’s Manual Park Ranger 2150 Operator’s Manual Park Ranger 2150
3.4 Hydraulic system
Hydraulic oil
Check the level of hydraulic oil while the oil is
cold.
The oil must be visible in the glass but not above
the red dot.
If the oil level is lower, refill the hydraulic oil tank.
(Picture 1)
Warning
Clean the area around the bleeding
and filling spigot before removing
the filler cap to prevent dirt entering
the hydrostatic system, where it may
cause damage.
Refilling hydraulic oil
A) Park the Park Ranger 2150 on a level surface.
B) Put the handbrake on, turn off the engine,
remove the radiator cover and open up the
bonnet.
C) Remove the bleeding and filling cap and pour in
Texaco Rando HDZ 68 hydralic oil. (Picture 2)
D) Replace the cap and start the engine.
E) Check that the oil fills ¾ of the glass while the
engine is running.
F) Close bonnet and mount the radiator cover.
Tank filter
Replace the filter and clean the housing during
service procedures. (Picture 3)
Hydraulic oil filter
A) Remove the oil filter under the Park Ranger
2150 and let the oil run out until the tank is empty.
B) Lubricate the gasket with oil.
C) Fit the new filter.
D) Pour in approx. 16 litres of Texaco Rando HDZ
68 oil. Check that the oil fills 3/4 of the glass.
(Picture 4)
Warning
Do not work with the hydraulic system
before its cooled off. Use gloves and
glasses when working with hydraulics
Bleeding/filling cap Viewing
glass
Tank filter
Tank filter housing
Hydraulic oil filter
Service and Maintenance