Ega Master 56077, Operating Instructions Manual

Page: 7 / 18

7
clockwise until reach your required pressure. If the output pressure already more than you need,
first release the pressure( unscrewV1), then rotate valve V2 anticlockwise half circle,screw down
V1, then adjust valve V2 clockwise again until reach your required.
8. After finish the test, no-load running for half a minute to discharge the rest water, wipe dry it
store it in a place with good ventilation.
OPERATIONAL PROCESS (WASHING)
1.Plug in, screw on transparent water inlet in the inlet pipe, connect strainer, and put into the
container in reserve.
2.Tighten the hatch V2, screw on the black exhalent siphon (there is a red sealing gasket in
the manual). At the same time, connect the other end of pipe with the washing gun. Turn on the
switch, rotate valve V1 clockwise and change the pressure to 3.5 Mpa/35KG/Cm
2
/35BAR.
3.After washed machine, no-load running for half a minute, discharge excess water, wipe dry
and place in air-vent for next use. When you use it next time, adjust the valve V1 in time to ensure
that beginning too big to damage the machine.
ROUTING MAINTENANCE
1. Forbid no-load running for too long time, it will reduce the working life drastically.
2. It could be connected water inlet with faucet and test the pressure if the machine have not
pumped water.
3. The good handling when machine can’t holding pressure:
a. Check up the tightness of each connector.
b. Make sure the valve V1 is tightly secured.
c. Take apart cover, check if there is impurity adhere to the one-way valve 29 according to the
Explosive view. If yes, make cleaning.
4. Accumulated working for 50 hours, should disconnect cover and screw off part 07 (according
to the Explosive view) to check the oil whether deteriorate or reduce? If yes, replace or add.
PACKING LIST
Name Quantity Specification Note
Machine 1pc - -
Water inlet 1pc 1.8M Transparent
Strainer 1pc - Red
High-pressure pipe 1pc 1.8M 56077
Instruction manual 1pc - -