4. Installation
25
4.8
Connecting the Remote Control
The remote control (1) displays the current status and
is used to control the device. Mount the panel where it
is easily accessible.
1
2
3
4
Flush mounting:
1 remote
control
2 opening
3 frame
4 screws
Flush mounting
If installing the panel flush with the surface of the
unit, make sure that there is a sufficient opening for
the electronic components behind the opening.
Use templates for drilling and sawing when flush or
surface mounting (2). Use a drill to start the opening
and then cut out the rest of the opening with a keyhole
or compass saw.
Connect the remote control with the DL 2 data line
(included).
Then secure the control panel (1) with four suitable
screws (4) and place the frame (3) over the control
panel.
1
2
3
4
Surface mounting
Secure the surface mount with two screws.
Connect the remote control with the DL 2 data line
(included).
Then secure the control panel (1) with four suitable
screws (4) and place the frame (3) over the control
panel.
Surface mounting:
1 remote
control
2 surface mount
3 frame
4 screws