EFI E-36A, Installation And Service Manual

Page: 27 / 129

27 Installation and Service Guide: Color Controller E-36A
Installing Hardware
To disable the power synchronization
1 Turn off the printer using the main power switch.
Wait until the E-36A shuts down.
2 Set the switch on the back of the E-36A to the OFF position (see Figure 9 ).
3 Disconnect the USB power cable from the Type B USB port on the back of the E-36A, and from the USB port on
the printer.
Completing the installation
To complete the installation of the E-36A at the customer site, do the following:
1 Make sure that the E-36A is turned off and power switch on the back of the E-36A is in the ON (|) position.
2 Set the power synchronization switch on the back of the E-36A to ON position (see page 25 ).
3 Power on the printer.
The E-36A automatically starts up.
4 Print the Configuration page from Fiery QuickTouch to obtain the Fiery ID that is used as a Fiery default password
(see page 31 ).
Note: Fiery ID is referred to the ID field located under BIOS Setup section of the Server Configuration page.
5 Once the E-36A starts up, follow the on-screen prompts to complete the language selection, license agreement and
enter the server name.
6 If theE-36A requires a static IP address (for example, in a non-DHCP network environment), work with the
network administrator to configure it as described on page 28 .
7 Print the Test Page and Configuration page and ask the customer to verify the output (see page 30 ).
8 Perform any required system software upgrades. For instructions, see the documentation that accompanies the E-
36A system upgrade.
Updates to E-36A software may be available from a variety of sources (for example, System Updates (see page 105 )
or patches downloaded by the customer).
Windows operating system updates should be obtained from Microsoft directly. Because such updates are available
directly from Microsoft, EFI does not maintain or provide them via the System Updates feature.
9 If needed, change the factory default language.
For more information on changing the factory default language, see page 29 .
Do not change the switch position when the E-36A is powered on.
Do not change the switch position when the E-36A is powered on.