RandomDot-000
USER MANUAL
RandomDot-000
ID #016729[C]
Version 1.1.2021
MAJ:
10 mai 2021
To remove marks on the lens, wipe 1-2 drops of
non-alcohol-based
cleaning fluid in a gentle circular motion with a
cleaning tissue. Always apply the fluid to a tissue rather than the lens itself.
The product is supplied with a 24V constant voltage.
Please be careful to use a voltage comprised between 22V and 29V.
OPERATING THE PRODUCT
RandomDot-000 is an industrial white LED pattern projector. It must be used only for projecting its pattern on a
surface, excluding any other use.
The LED driver inside the product is set to automatically pulse the LED.
If you trigger light for a short pulse (< 25 ms), light is pulsed (LED are driven at 2,2A).
If your pulse is longer, the driver automatically decreases LED current to 0,4A (18% of max current) to protect LED
against failure.
Maximum T
ON
= 25 ms
Minimum T
OFF
= 25 ms
Response rise time : 35 µs
Response fall time : 30 µs
Peak consumption : 44W
Continuous mode consumption : 10W
Changes or modifications not expressly approved by the manufacturer could void the
user’s authority to operate the
equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)
This device may not cause harmful interference,
and
(2)
This device must accept any interference received, including interference that may cause undesired operation
STATUS LED
LED color
Designation
Red
Overtemperature security
Activated when the
temperature of the LED
reaches 75°C
Green
Lighting ON
Blue
TRIG signal IN
Electronical consideration
