STEADY
RUN
SETUP
CYCLE
STOP
Slow
t
Pressure
Time
Slow
t
®
A NORDSON COMPANY
2000XL
Power Input Receptacle with Voltage Selector and Fuse Cartridge
Three input voltages can be used: 100 VAC, 120 VAC and 220 VAC. To
change input voltage, remove fuse cartridge and position the selected
voltage marked on the cartridge so that it shows through the window.
(Details on page 8.)
I
nput/Output 9 Pin Interface Connector
The input/output features are used when the dispenser is interfaced with
external control circuits.
• An End-of-Cycle signal, in the form of a solid-state switch, closes upon
completion of the dispense cycle. Maximum load is 250mA from 5 to
24 VDC.
• The 2000XL can be initiated using a 5 to 24 VDC signal.
• Contact Closure.
(For more details, refer to page 22.)
In the upper right corner of the
front panel are four indicator
lamps. These lamps indicate
the mode of operation.
STEADY
- Indicates that the
timing feature has been
overridden and that the output
is controlled by the length of
time the foot pedal is pressed.
RUN
- Indicates that the
dispenser is in the
RUN
mode
ready to be initiated through a
dispense cycle. In this mode,
time settings cannot be
changed.
SETUP
- Indicates that the
dispenser is in the
SETUP
mode. In this mode, time
settings can be changed.
CYCLE
- This lamp is on during
the dispense cycle.
Indicator Lamps
Fuse T 125mA 250V
100/120/220VAC
50/60Hz 10/9VA
Air
Input
Foot
Pedal
7. Contact Closure
5. Contact Closure
6. Chassis Ground
8. Not Used
9. Not Used
1. Initiate
+
2. Initiate
-
3. Output
+
4. Output
-
5-24 VDC
5-24 VDC
250mA
Exhaust
Air
Output
I/O 9 pin interface
connector
Air input
Voltage selector
and fuse cartridge
Exhaust
Foot pedal
receptacle
Power input
receptacle
Power
switch
Air output
quick-connect