Efco SWAPLOADER SL-145, Parts And Operation Manual

Page: 4 / 99

SWL Pre-Delivery Check List Page 2 Revision A
III. CONTROLS
Controls easy to operate from driver’s seat.
Movement of controls correct, per installation instructions.
IV. HYDRAULIC INSTALLATION
Correct hydraulic oil level in reservoir, per installation instructions.
Inspected for leaks.
Any abnormal noise during hoist operation? YES NO
If yes, please describe:
With engine operating @ 1,000 RPM, record the following information:
Cycle time for dump mode: Seconds Up Seconds Down
Cycle time for load/unload mode: Seconds to Unload Seconds to Load
Filter pressure: PSI
Main pressure, controls in neutral: PSI
Main relief pressure when extending
jib cylinder (bottomed out): PSI
Main relief pressure when extending
lift cylinders (bottomed out): PSI
NOTE: Connect pressure gauge to fitting provided on the inlet section of the Hydraulic Control Valve (Ref. Part
No. 10P37, fitting on Hydraulic Pump Circuit Drawing found in the Parts List section of the Hoist’s Parts &
Operations Manual).
V. OPERATION
Jib operates freely in both directions.
Jib cannot be extended or retracted when raised in dump position or when pivot joint is tilted in unload
position. Both safety hooks are fully engaged when jib is extended.
Parts & Operations Manual is in the cab.
Lubricate sliding jib and all grease zerks per installation instructions.
VI. DECALS
All safety decals and product decals installed per enclosed decal drawings (found attached to the inside
of the hoist’s Parts & Operations Manual cover or at the back of the Parts List section in the Manual).
Additional Comments:
COMPLETE & SAVE TO YOUR COMPUTER. RETAIN A COPY FOR YOUR FILES.
ONCE COMPLETE, FAX ( 515-313-4426 ) OR EMAIL ( sales@swaploader.net ) A COPY BACK TO SWAPLOADER!
1800 NE Broadway Ave., Des Moines, IA 50313 • www.swaploader.com • Toll Free: 888-767-8000