Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
8
WK 850 - 100618
Back cover page
Assembly page 8/30
Fax +32 2 359 95 50
BEFORE THE FIRST OPERATION
For the perfect taste, operate the jug kettle with fresh water in order to clean any residue left
from the manufacturing process. When the appliance has cooled down, repeat the process 3
times with fresh water, before rinsing.
OPERATION
•
Always remove the jug from the power base before filling it or before any operation.
•
Open the lid by pressing its release button and fill the tank with fresh water, paying
attention not to fill under the minimum mark and above the maximum mark on the water
level indicator.
•
Close the lid by pressing it down until it you hear a click. Make sure it closes correctly.
•
Put the jug onto the power base, plug into the wall socket and switch on by pressing down
the switch situated on the handle. The blue pilot light comes on indicating the appliance is
operating.
•
The jug kettle will switch off automatically when the water has boiled. However, you can
stop the jug kettle anytime by putting the switch in off position.
•
For instant reboiling, wait until water has cooled down and switch on the appliance again.
SAFETY CUT-OUT
•
This jug kettle is protected with an automatic safety device if accidentally switched on
without water. Please bear in mind that only the thermostat is switched off in case of
overheat, whereas the switch stays in ON-position.
•
In this case, switch off the appliance by putting the switch in OFF position and wait about
10 minutes for the element to cool. Then pour in sufficient cold water to cover the
element. This will reset the safety device.
•
The kettle may then be used as normal.
CLEANING AND MAINTENANCE
•
Before attempting any cleaning operation, make sure the appliance is unplugged from
the supply socket and fully cooled down.
•
To clean the exterior surfaces, simply wipe over with a soft damp cloth and dry thoroughly.
•
Never use abrasive products
•
On no account must the jug kettle or its power base be immersed in water.
FILTER
•
Your appliance is provided with a filter. When you want to boil water, settle the filter first.
•
When the lid is open, you can remove the particle filter by pulling it and clean it under
running water.
•
Filter should be rinsed clean regularly.
DESCALING
To remove scale from the jug kettle, use products made especially available for this purpose.
Make sure to use a type recommended for plastic kettles.
PROTECTION OF THE ENVIRONMENT– DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
