Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
8
WK 1020 - 120418
Assembly page 8/20
Fax +32 2 359 95 50
(*)
Competent qualified electrician: after-sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this electrician.
BEFORE THE FIRST OPERATION
For the perfect taste, operate the jug kettle with fresh water in order to clean any residue left
from the manufacturing process. When the appliance has cooled down, repeat the process 3
times with fresh water, before rinsing.
OPERATION
Always remove the jug from the power base before filling it or before any operation.
Open the lid by pressing its release button and fill the tank with fresh water, paying
attention not to fill under the minimum mark and above the maximum mark on the water
level indicator.
Close the lid by pressing it down until you hear a click. Make sure it closes correctly.
Put the jug onto the power base, plug into the wall socket and switch on by pressing down
the switch situated on the handle. The red pilot light comes on indicating the appliance is
operating.
The jug kettle will switch off automatically when the water has boiled. However, you can
stop the jug kettle anytime by putting the switch in the off position.
For instant reboiling, wait until the water has cooled down and switch on the appliance
again.
SAFETY CUT-OUT
This jug kettle is protected with an automatic safety device that switches off the appliance
if it is accidentally switched on without water. Please bear in mind that only the thermostat
is switched off in case of overheating, whereas the switch stays in the ON-position (I).
In this case, switch off the appliance by putting the switch in the OFF position (0) and wait
about 10 minutes for the heating element to cool. Then pour in sufficient cold water to
cover the heating element. This will reset the safety device.
The kettle may then be used as normal.
CLEANING AND MAINTENANCE
Before attempting any cleaning operation, make sure the appliance is unplugged from
the supply socket and fully cooled down.
To clean the exterior surfaces, simply wipe over with a soft damp cloth and dry thoroughly.
Residues on the interior surfaces can be removed with a soft brush.
Never use abrasive products.
On no account must the jug kettle or its power base be immersed in water.
The flocked parts are water-resistant and can be cleaned with a damp cloth.
FILTER
Your appliance is provided with a filter. When you want to boil water, settle the filter first.
When the lid is open, you can remove the particulate filter by gently press out from the
inside to the front at the top and rinse under running water.
The filter should be rinsed clean regularly.
