EEZ RV EezTire E518, Manual, Page: 10 / 35

10
Using the set key scroll to your first axel “HIGH’ pressure. Use the plus
or minus to set your HIGH PRESSURE. When you reach your desired
pressure press and release the “SET’ button again and ‘LOW
PRESSURE’ will be displayed. Use the plus or minus keys to set your
low pressure. Press the set button again and the next axel will flash
“HIGH PRESSURE”. Make your adjustments the same way as for the
first axel. Skip any axels that you are not using and just keep hitting
the “SET” button until you get to the axel that you want to set.
When you have finished setting your parameters PRESS and HOLD the
SET button until the monitor beeps and you are back to display mode.
Keep in mind that the monitor will time out in 40 seconds. So, wright
down your settings before you start.
PROGRAMMING SENSORS TO THE MONITOR
METHOD 1 tabletop (this is the easiest way)
1. Using the switch on the left side center of the monitor, push it up to
turn on the monitor. Place the monitor flat on the table in front of
you. Then place your numbered sensors on the table about a foot
away from the monitor.
2. Press and hold the CODE button on the lower right side down for 3
seconds until you hear the beep. At this time, you will see all 26 tires
on the monitor screen, and the right front tire will be flashing. After
programing only, those tires that you program will show on the
monitor. That is tire number 1. Following your diagram on the back of
your Manuel, place the first sensor on the table and push it against
the base of the monitor next to the set button. You will see
“ FFF FFF ”
on the screen. All F's means that that sensor is not programmed yet.
Then press and release the code button one time. The monitor will