The monitor comes equipped with a light sensor; the backlight will
typically come on if the vehicle is in motion and the light level is low
enough. You may also wave your hand in front of the monitor to
manually activate the backlight or by pressing any button. It can be
turned off by pressing the+ button for 3 seconds. The light sensor
is located on the lower left of the monitor, just left of the "LINK" button.
The monitor comes with a built-in motion sensor; it will go to sleep
(energy saver mode) if there is no movement of the vehicle detected for
approximately 15 minutes and wake up when it detects movement.
It is recommended that the monitor is shut off when the system is not in
use, or you are staying in the vehicle overnight.
- When external power is applied to the monitor it will override the
manual on/off switch on the left side. If you hard wire your system
charger to a "keyed" switch the system will go off when the keyed power
is turned off. If you are using the auxiliary charging cord, you will have to
unplug the charger manually.
- You
will
get a longer service life from your monitor-s internal battery
if you disconnect the external power source and allow the battery to
deplete through normal operations every couple weeks naturally.
The factory default settings are as follows: High Pressure (175 PSI), Low
Pressure (100 PSI), Temperature (158 °F). To restore Factory Defaults: Turn off
the monitor; press the SET button and activate the monitor at the same time.
The RED light will flash, and factory settings will be restored.
Pressure Unit:
PSI
High Pressure:
175 psi (12.1 BAR)
Low Pressure:
100 psi (6.9 BAR)
Temperature Unit
OF
High Temperature:
158 °F (70 °()
RESTORE PARAMETERS to FACTORY DEFAULTS:
Turn off the monitor; press the SET button and activate the monitor at the same time.
The RED light will flash, and factory settings will be restored.
Pressure Unit: PSI High Pressure: 175 psi (12.1 BAR) Low Pressure: 100 psi (6.9
BAR) Temperature Unit: OF High Temperature: 158 °F (70 ° ( )
MONITOR INSTALLATION
Your system comes with three mounting options: a plastic tower with suction
cup mount for window or dash, low profile mount for dash, low profile triangle
mount for dash. Some people prefer to use Velcro or the small bean bags used
for cell phones on their dash.
12 - - - - - - - - - - - - - -
HIGH LOW PRESSURE