Edwards xds35i, Instruction Manual, Page: 35 / 40

In
de
x
A730-01-880 Issue E
© Edwards Limited 2007. All rights reserved. Page 29
Edwards and the Edwards logo are trademarks of Edwards Limited.
A
Accessories ............................................... 27
ATEX directive implication ...............................2
C
Clean the external fan cover .......................... 22
Connect the pump to your electrical supply ........ 13
Construction ................................................4
D
Description ..................................................3
Disposal ................................................... 25
E
Electrical data .............................................7
Electrical installation ................................... 12
F
Fault-finding .............................................. 22
Flammable/pyrophoric materials ..................... 16
G
Gas ballast control ........................................4
Gas purges ................................................ 16
General characteristics ...................................5
I
Implication of ATEX directive .......................... 16
Inlet and outlet connections ........................... 13
Inspect and clean the gas ballast control ............ 21
Inspect and clean the inlet strainer .................. 20
Installation ..................................................9
Introduction ................................................1
L
Leak test the system .................................... 14
Locate the pump ......................................... 12
M
Maintenance .............................................. 19
Maintenance plan ........................................ 19
Mechanical data ............................................6
O
Operating and storage conditions .......................5
Operation ................................................. 15
P
Performance characteristics .............................5
R
Remote operation using 15 way D connector ....... 17
Replace the tip seals .................................... 22
S
Safety .......................................................9
Scope and definitions .....................................1
Service .................................................... 27
Shut down ................................................ 17
Spares ..................................................... 27
Start up procedure ...................................... 15
Storage .................................................... 25
System design considerations .......................... 10
T
Technical data ............................................. 5
Test the motor condition ............................... 22
U
Unpack and inspect ..................................... 12
Use of gas ballast control .............................. 15
V
Vibration data .............................................. 6
Index