© Edwards Limited 2014. All rights reserved.
Page 41
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service and spares
A311-03-880 Issue A
7
Service and spares
7.1
Introduction
Edwards products, spares and accessories are available from Edwards companies in Belgium, Brazil, China, France,
Germany, Israel, Italy, Japan, Korea, Singapore, United Kingdom, USA and a world-wide network of distributors. The
majority of these employ service engineers who have undergone comprehensive Edwards training courses.
Order spare parts and accessories from your nearest Edwards company or distributor. When you order, please state
for each part required:
Model and Item Number of your equipment
Serial number (if any)
Item Number and description of the part
7.2
Service
Edwards products are supported by a world-wide network of Edwards Service Centres. Each Service Centre offers a
wide range of options including: equipment decontamination; service exchange; repair; rebuild and testing to factory
specifications. Equipment which has been serviced, repaired or rebuilt is returned with a full warranty.
Your local Service Centre can also provide Edwards engineers to support on-site maintenance, service or repair of
your equipment.
For more information about service options, contact your nearest Service Centre or other Edwards company.
7.3
Spares
The spares available for the HV8000 pumps are shown in
.
Spares kits have been structured such that they are progressive in nature up to and including kit A31101806. It is our
recommendation that in order to maximise the benefit of any replacement, then one should also replace the items
defined in the spares kits with lower part numbers than that of the kit required for the defined task.
For example, when changing the gears, we would recommend that you should also change the mechanical seal (with
the shaft sleeve) and the O-rings.
Thus, in addition to kit A31101804, one would also require kits A31101803 and A31101801.
It is also permitted to change the bearings without simultaneously changing the gears. One will require kits
A31101805, A31101803 and A31101801 to carry out this task.
Note:
Kit A31101802 has been provisioned for use when one wishes to change the mechanical seal without
changing the shaft sleeve at the same time.
Kits with part numbers of A31101807 and higher may be used in isolation.
