Deutronicstr. 5, D - 84166 Adlkofen, Germany
Tel.: +49 (0) 8707 920-0
Fax: +49 (0) 8707 1004
E-mail: [email protected]
http://www.deutronic.com
DBL Operating Instructions / MPC4
Last updated: 03.12.2020
Page 14 of 26
Q
max
in [Ah]
Maximum battery
charge capacity
[0 … 6000] Ah; Limiting value from which on the
charging process will be stopped with an
application error. The value has to be adapted
depending on the battery to charge or depending
on the (production) process. [3]
T
min
in [min]
Minimal charging
time
[0 … 240] minutes; Before a changeover from
charging mode to trickle charging can take place
this time interval has to pass.
T
max
in [h]
Maximum charging
time
[0 … 255] h; Maximum time interval after which
the charging process is finished with an
application error [4].
FEATURES
Characteristics
A new submenu is opened (see chapter 5.5.5).
[1] Starting voltage [U
min
] - SAFETY NOTE:
The starting voltage represents a safety limit. This limit ensures by an
appropriate correct configuration that a technically accurate battery is
connected for the charging process! Information: In the operation mode
AUTOMODE due to safety reasons no batteries are accepted which show
a lower voltage than 11.5 VDC. Nevertheless, if it is necessary to charge a
motor vehicle battery with a lower voltage, please switch from AUTOMODE
in the operation mode CHARGEMODE.
[2] Current limit [I
max
]:
If the configured current maximum Imax is available on the output
depends on the (load) condition in the operating status. Note: During
SUPPLYMODE the output current limit can automatically be
adjusted/reduced via the dynamic output power and temperature control.
[3] Maximum loading quantity [Q
max
]:
Hint for a complete charge of the battery without parallel electrical
consumers: Rise the limit value in the setup configurations round 10…20%
than nominal given for the battery capacity by the battery manufacturer.
Please note: The behaviour of the device when achieving the safety
threshold depends on customized terms of delivery (e.g. switch off output
current, limitation of charging voltage to U
tri
or no reaction if these
parameters were predefined by terms of delivery).
[4] MAXIMUM CHARGING TIME [T
max
]:
Please note: The behaviour of the device in achieving the safety threshold
depends on customized delivery conditions (e.g. switching off output
current, limiting charging voltage to Utri or to no reaction, if these
parameters were defined by terms of delivery).
