Edmonds AiroMatic, Product Manual, Page: 15 / 20

15
Painting the Airomatic

Check that the cable is sitting in the notch of the flashing.

Check that the fan is orientated correctly with the motor/fan
unit in exhaust configuration

Check all screws are in place

Check that the fan blades rotate freely and are not impeded
All screws should be hand tightened until snug. Do not over tighten screws
as this may cause them to strip out of the plastic
STEPS 5,6,7
Reassemble the
Airomatic using
the reverse of the
steps used to
disassemble.
When attaching
the flashing make
sure to align the
notch in the
flashing up stand
with the cable exit
STEP 8
Post assembly check.