Solution-8 Installation Manual
Page 13
Electronics Design & Manufacturing
ISSUE401.DOC
Command 264
This command erases all data from the Programming Key. Insert the Key into the programmer and enter the
command 264 followed by the AWAY key. Three beeps will be heard and all data from the Key will be erased.
This feature is useful if you wish to give a Key to someone else without them having access to the previous data.
V3
Command 265
Command 265 has been added to make the programming of Domestic Dialling a one step operation. When in
Installers programming mode press 265 followed by the AWAY key. This will automatically set the following
locations as below.
Location
Description
Setting
Location 49
Handshake
2 (1400 Hz)
Location 50
Transmission Format
11 (Domestic)
Location 52 - 55
Unit ID
0001
Location 196 & 197
AC Fail
0 & 0
Location 198 & 199
Low Battery
0 & 0
Location 200
Open Report
0
Location 201
Close Report
0
Location 203
Alarm Restore
0
Location 204
Trouble Code
0
Location 205
Trouble Restore
0
Location 206
Bypass Code
0
Location 207
Bypass Restore
0
Location 208 & 209
Keyboard Tamper
0
Location 252 & 253
First Test Report
0
No other locations will be altered when the command 265 is issued. This means that things such as entry and exit
times, siren run time etc will not change.
Command 266
This feature enables or disables the automatic stepping of locations while programming. When enabled via the
Solution
Programmer the decimal point of the left most display will reflect the mode of operation. If the
decimal point is illuminated then Auto Step mode is active. An automatic increment of the location being
programmed will occur as soon as the STAY button is pressed positioning you at the next location ready for
programming. If the decimal point is extinguished, the Auto Step mode is disabled. The next programming
location will need to be manually selected.
