REF.
07591
INSTRUCCIONES IMPORTANTES DE SEGURIDAD
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
ACCESSORIES
9 mm
3 mm
12 mm
6 mm
Hair comb
Cleaning brush
Lubricant
Cutting shears
LEAF ALIGNMENT
- This appliance has been rigorously inspected to ensure that the blades
were greased and aligned before leaving our factory.
- Sheets must be realigned if they have been removed for cleaning and
replacement.
- To realign the blades, simply match the top and bottom teeth of the
blades up, point by point. (The end of the blade teeth should be
approximately 1.2mm from the bottom of the blade. Compare the blade
blades with the drawing.)
- If the blade alignment is incorrect, add a few drops of oil to the blades,
turn on the appliance for a few moments, turn off and unplug. Slightly
loosen the screws and adjust. Tighten the screws after correct align-
ment of the blade.
OIL
- To keep your hair clipper in perfect condition, the blades should be
greased every few haircuts.
- Do not use hair oil, grease, chemicals or abrasives. Any product not
specific to the device can damage it and even spoil it.
BLADE LEVER
- The lever is located near the thumb (if it is right-handed) so that it can
be easily adjusted while the hair clipper is in your hand.
- The lever adds versatility to your hair clipper by allowing you to
gradually change the closeness of your cut without an accessory comb.
- When the lever is in the highest position, the blades will give you the
closest cut and short hair. Pushing the lever down gradually increases
the cutting length.
- In its lowest position, the lever will leave the hair approximately the
same length as a # 1comb.
- The lever will also expand the use of the blades, since a different
cutting edge is used in each adjustment.
- Also, if the extremely heavy haircut has jammed the blades, it will help
remove the hair that has wedged between the two blades without
removing the blades.
- While the trimmer is running, quickly move the lever shape from "close
cut" to "longer cut" a couple of times. Doing this every time you have
finished using your hair clipper will help keep the blades clear of cut
hair. If our machine stops cutting and this doesn't help, you should
replace your blades.
SECURITY
When using electrical appliances, especially when children are present,
basic safety precautions should always be followed, including the
following:
To reduce the risk or death or injury from electric shock:
- Unplug this appliance before cleaning it.
- Do not place or store the appliance where it can fall or be dragged into
a bathtub or sink.
- Do not use it while bathing or showering.
- Do not place or drop into water or another liquid.
- Do not look for an appliance that has fallen into the water. Unplug
immediately.
To reduce the risk of burns, electrocution, fire, or injury to persons:
- Use this appliance only for its intended use, as described in this
manual. Do not use accessories not recommended by the manufacturer.
- This appliance should never be left unattended when plugged in.
- Close supervision is necessary when this appliance is used by, on or
near children or the disabled.
- Never use this appliance if it has a damaged cable or plug, if it does not
