Version of 16 April 2018
17
DiSEqC:
Set the value for DiSEqC here.
Regulator:
If you use a mechanised control system, specify here its mode.
22KHz:
This item is available only if you have not selected the ‘Universal’
value in the ‘LNB Type’ menu. Then you can enable/disable the
22KHz connection mode. The 22KHz connection mode is used for
switching the lower and upper frequency band in LNB.
0/12V:
If you use a 12V switch, set the value to ‘On’.
Polarity:
Here you can set the polarity.
Tone Burst:
Tone Burst is another mode option availed by the receivers. This
signal does not include digital commands, but can be recognised and
used by most switches for position toggling. Set the value to ‘On’ or
‘Off’.
LNB Power:
Set this parameter to ‘On’ or ‘Off’.
Use the red button to move to the channel scan menu of the installed satellite. In this menu, the following
settings are available:
Scan mode:
Select between All (channels) or Free (channels).
Programme Type:
Define the scan for television, or radio, or television and radio
channels.
Select scan mode:
Choose between “Manual Scan” or “Blind Scan”.
NIT scan:
Decide whether the NIT (Network Information Table) is going to be
used for scanning.
Use the OK button to start the scanning process. You can exit the menu window at any time with the EXIT
button.
Use the green button to switch to the multiple satellite channel scan menu. For this purpose, select using
the OK button in the displayed list the satellites according to which the satellite reception system has been
aligned and installed. Then press the red button and specify (if necessary) the following settings again:
Scan mode:
Select between All (channels) or Free (channels).
Programme Type:
Define the scan for television, or radio, or television and radio
channels.
Select scan mode:
Choose between “Manual Scan” or “Blind Scan”.
NIT scan:
Decide whether the NIT (Network Information Table) is going to be
used for scanning.
Use the OK button to start the scanning process. You can exit the menu window at any time with the EXIT
button
The blue button initiates the automatic recognition of potential satellites via DiSEqC. If any satellites have
been identified on the basis of the installation or the alignment of the satellite reception system, these will
appear on the display. The ‘Scan‘ button provides the following variable settings:
Scan mode:
Select between All (channels) or Free (channels).
Programme Type:
Define the scan for television, or radio, or television and radio
channels.
Select scan mode:
Choose between “Manual Scan” or “Blind Scan”.
NIT scan:
Decide whether the NIT (Network Information Table) is going to be
used for scanning.
Use the OK button to start the scanning process. You can exit the menu window at any time with the EXIT
button.
Use the white button (PLAYMODE button) to start the automatic scan (Blind Scan) according to the above
settings.
Use the ‘MUTE’ button to stop and reset the buzzer.
You can exit the ‘Satellite Setup’ menu with the EXIT button.
Summary of Contents for OS mini DV3 S2
Page 31: ...Version of 16 April 2018 31 ...
