56
Configuration Settings
By using iLINK to connect the F-1 with an VC-50HD Field Converter, you can capture video
from a camera equipped with SDI output, as well as provide playback with respect to
equipment that accepts SDI input.
* Before you connect the F-1 to the VC-50HD, you need to set the VC-50HD’s No. 6 mode selection
switch to “ON.” For details, refer to “Using the VC-50HD with the EDIROL F-1” in the VC-50HD’s
Owner’s Manual.
* You can synchronize to recordings made by a camera that accommodates SDI remote control and
initiate capture if you select the setting “Sync” under “Sync Rec” (p. 44).
* Menu items 200 and 201, which are concerned with the VC-50HD, are displayed only when the
F-1 is connected to an VC-50HD.
Here’s how to set the codec that is to be used when capturing an SDI signal being input to the
VC-50HD.
1
Press the [MENU] button to access the Menu screen,
and select the “Codec Type.”
Select the “Codec Type” with the [
(
)] [
(
)]
buttons, and then press the [
(ENTER)] button.
2
Select the desired type of codec with the [
(
)]
[
(
)] buttons.
* When this setting is changed, the F-1 may need to be restarted,
depending on the value of the setting.
* If "Codec type" is set to "MPEG-2 TS," the "Pre-record" (p. 46)
time (3 seconds) will change depending on the bit rate.
(Anywhere from 2 seconds to 37 seconds)
* If the "Codec type" is set to "MPEG-2 TS 50/12Mbps" and you
are inputting an HD signal to the VC-50HD, the "Pre-record"
setting (p. 46) will be ignored.
* If the "Codec type" is set to "MPEG-2 TS 8/2Mbps" the "Loop
Length"(p. 47) setting will set to "60min".
Using the F-1 in Combination with the EDIROL VC-50HD
Setting the Codec to be Used When Captures are Carried Out
Value
Description
HDV
Captured in HDV format.
DV
(NTSC)
Captured in DV (NTSC) format.
DV
(PAL)
Captured in DV (PAL) format.
MPEG-2 TS 35/9Mbps
Captured in MPEG-2 TS format using the
selected bit rate.
MPEG-2 TS 50/12Mbps
MPEG-2 TS 8/2Mbps
07_settings_e.fm 56 ページ 2009年4月20日 月曜日 午前9時55分