4
ENGLISH
FOR THE TECHNICIAN
INSTALLER
Installation in the place of Asola
To install the Remote control update:
- the Firmware on the basic circuit board with a
version from PELE1711 onwards
- complete APF, if the installed revision is below rev 103.
In order to do that, copy the updated APF of the
product in the USB pen-drive supplied with the
Remote control (and containing the firmware).
Insert the USB pen-drive into the product’s USB
socket and supply power to the product. After
about 30 seconds, a beep will signal that the
reprogramming has completed successfully.
At this point the Phoenix must be linked with the
product.
The remote control will show this display.
To link the Remote control with the product, disconnect
and restore power to the basic circuit board.
When you hear the beep, press the key on the remote
control
. This display will appear:
When the Remote control finds a compatible
communication, the linking procedure will terminate
automatically.
If the remote control does not find any compatible
communication, it will again display “No network”.