EdgeStar BR3002BL, Owner'S Manual

Page: 9 / 22

4
NOTE:
This appliance is designed for “indoor” use only and should not be used outdoors.
WARNING: Use two more people to move and install the kegerator. Failure to do so can result
in back or other injury. Carefully remove the packaging materials. Remove any shipping tape
and glue from your kegerator before using. Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage
the surface of your kegerator.
IMPORTANT: Do not remove any safety, warning, or product information labels from your
kegerator.
Installing the Kegerator
To ensure the kegerator will last, install it in a location where there is proper air circulation and
electrical connections. Keep the refrigerator away from heat and direct sunlight. This cooler is
designed for indoor use only and should not be used outdoors. It should
not be placed in a built-
in or recessed area as it is designed to be a freestanding kegerator.
The following dimensions are the recommended clearances around the beer dispenser:

Sides - 4
” (76mm)

Back -
4 to 5” (127 mm)
The kegerator should be installed in accordance with local electrical code requirements. The
kegerator should also be placed in a location that is strong enough to support its total weight,
keeping in mind that it will weigh substantially more when fully loaded than when empty.
Before you plug the kegerator into a power supply, be sure to let it stand upright for at least 24
hours to allow the compressor’s oils to settle.
Unpacking the Kegerator