Edge-Core ES3526VA-PoE, Installation Manual, Page: 42 / 74

Installing the Switch
3-10
3
Connecting to a Power Source
To connect a switch to a power source:
1. Insert the power cable plug directly into the AC receptacle located at the back of
the switch.
Figure 3-8 Power Receptacle
2. Plug the other end of the cable into a grounded, 3-pin socket, AC power source.
Note: For international use, you may need to change the AC line cord. You must use a line
cord set that has been approved for the receptacle type in your country.
3. Check the front-panel LED indicators as the device is powered on to be sure the
PWR LED is lit. If not, check that the power cable is correctly plugged in.
4. If you have purchased a Redundant Power Supply, connect it to the device and to
an AC power source now, following the instructions included with the package.
Connecting to the Console Port
The DB-9 serial port on the switch’s front panel is used to connect to the switch for
out-of-band console configuration. The command-line configuration program can be
accessed from a terminal or a PC running a terminal emulation program. The pin
assignments used to connect to the serial port are provided in the following table.
Figure 3-9 Serial Port (DB-9 DTE) Pin-Out
100-240V~
50/60Hz 8.0-2.0A
1 5
6
9