Edge-Core ES3510MA, Management Manual

Page: 935 / 984

C
HAPTER
41
| IP Interface Commands
IPv6 Interface
– 935 –
show ipv6 interface
This command displays the usability and configured settings for IPv6
interfaces.
S
YNTAX
show ipv6 interface [ brief [ vlan vlan-id [ ipv6-prefix / prefix-length ]]]
brief - Displays a brief summary of IPv6 operational status and the
addresses configured for each interface.
vlan-id - VLAN ID (Range: 1-4093)
ipv6-prefix - The IPv6 network portion of the address assigned to
the interface. The prefix must be formatted according to RFC 2373
“IPv6 Addressing Architecture,” using 8 colon-separated 16-bit
hexadecimal values. One double colon may be used in the address
to indicate the appropriate number of zeros required to fill the
undefined fields.
prefix-length - A decimal value indicating how many of the
contiguous bits (from the left) of the address comprise the prefix
(i.e., the network portion of the address).
C
OMMAND
M
ODE
Normal Exec, Privileged Exec
E
XAMPLE
This example displays all the IPv6 addresses configured for the switch.
Console#show ipv6 interface
Vlan 1 is up
IPv6 is enable.
Link-local address:
FE80::2E0:CFF:FE00:FD/64
Global unicast address(es):
2001:DB8:2222:7273::72/96, subnet is 2001:DB8:2222:7273::/96
Joined group address(es):
FF02::1:FF00:72
FF02::1:FF00:FD
FF02::1
IPv6 link MTU is 1280 bytes
ND DAD is enabled, number of DAD attempts: 3.
ND retransmit interval is 1000 milliseconds
Console#
Table 140: show ipv6 interface - display description
Field Description
VLAN A VLAN is marked “up” if the switch can send and receive packets on this
interface, “down” if a line signal is not present, or “administratively down”
if the interface has been disabled by the administrator.
IPv6 IPv6 is marked “enable” if the switch can send and receive IP traffic on this
interface, “disable” if the switch cannot send and receive IP traffic on this
interface, or “stalled” if a duplicate link-local address is detected on the
interface.