9
INSTALLATION AND START-UP
The in-situ installation and start-up of this appliance must be carried out by
qualified technical personnel.
Avoid having direct sources of heat, cold, humidity, sunlight and ultraviolet rays
in the final location of this appliance. Heaters, radiators, air conditioning, etc. can have
a negative influence on the correct operation of the same
Check that the voltage and frequency of the electricity supply network coincide
with those described in the characteristics plaque. It is essential that the electricity
installation where the appliance is to be installed has an earth connection, as well as the
necessary protection of a thermal magnetic switch and a circuit breaker. Do not connect
other appliances in the same electric socket.
Remove the outside plastic and any remaining adhesive covering the steel.
The VFIL models have their own base and consequently do not require any
specific installation. For the rest of the models the steps to be followed are detailed
below:
The present manual shows the holes to be made in the worktop depending on the
display cabinet model (2, 3, or 4 GN). Said holes are the same than those when the
display cabinet is installed in another element of the Drop-in range by Edesa or on any
worktop of the owner.
After that, once the electricity connections have been threaded through, the
display cabinet should be assembled following the steps below (see illustration with the
numbered steps)
2
5
3
6
4
4
7
4
1
2
5
8
