EDER EHA150, Operating Instructions Manual

Page: 4 / 8

4 EDER hydraulic unit 245503_00 | 10.2021
EN
Application area
The EDER hydraulic power unit EHA150 is suitable for use at an oil pressure of 150 bar
and an oil flow of 14l per minute. The power unit is driven by an economical Honda GX200
4-stroke petrol engine with an output of 4.3 kW (5.8 hp). The unit is built into a carrying
frame and can thus be transported by one or two persons with its low weight of approx. 30
kg.
Accessories: The EDER hydraulic unit EHA150 is particularly suitable for operating the
EDER splitting unit EHG1.
The EDER hydraulic unit is not suitable for operation without hoses and connected
equipment.
Safety instructions
1.
Read the operating instructions for the hydraulic unit and the engine before use and
pay attention to all warnings and safety instructions. Keep the operating instructions for
future reference.
2. The EDER hydraulic unit and the equipment connected to it may only be operated by
persons who have been instructed and trained in the use of hydraulic equipment.
3. Do not use the EDER hydraulic unit if you are tired, confused or under the influence of
sedatives, sleeping pills, alcohol or drugs.
4. The EDER hydraulic unit may only be used in sufficiently good lighting conditions.
5.
The operationally safe condition of the unit must always be checked before starting
work.
6.
The EDER hydraulic unit must not be used if damage to the unit or to the hydraulic
system and hoses has been detected.
If leakage is suspected, do not feel the hydraulic unit and hoses with bare hands. An
oil jet escaping at high pressure can cause serious injury.
7. Suitable tools must be used for maintenance and set-up work.
8.
Protection and safety devices must not be rendered ineffective.
9. Before starting work, make sure that you are standing securely and remove any
obstacles in the working area if necessary.
10. Do not interfere with the mechanics during operation.
11.
The EDER hydraulic unit is operated with a combustion engine and can therefore
become very hot. The EDER hydraulic unit must not be used in closed rooms.
12.
Make sure that the unit you connect to the EDER hydraulic unit is suitable for at least
150 bar.
Commissioning
For the initial start-up of the EDER hydraulic unit, the following operating materials must be
filled into the engine:
1.) Up to 3 litres of petrol in the petrol tank (without additives, no two-stroke mixture! )
2) SAE 10W-30 is recommended for general use.
For further details, please refer to the motor operating instructions.