23
Attachments with chain drive
409001_01 | 12.2020
Fig. 10:
Replacing knives on the groove cutter
ATTENTION
> Replace the clamping nut after each disassembly!
EDER Wire Brush ERB-C
Changing the wire brush
Fig. 11:
Changing the wire brush
> Unscrew the drive sprocket using the pin wrench.
> Unscrew the
short bearing shaft
and the
long bearing shaft
.
> Remove the wire brush from the housing and loosen the locking plate
by bending back its bent lug so that the grooved locknut can turn
freely.
