21
Attachments with chain drive
409001_01 | 12.2020
You can set the cutting depth to 0.4 mm, 0.7 mm or 1 mm with the
supplied Allen wrench.
The knives must not protrude more than 1 mm beyond the guide plate.
Fig. 7:
Knife adjustment
Proceed as follows for each knife:
> Loosen the Allen screw of the knife with a 6 mm Allen wrench.
> Replace the knife (
2
– Fig.7) if necessary.
> Turn the cylinder (
1
– Fig.7) so that the knife protrudes at maximum
through the guide plate (
3
– Fig.7).
> Place the Allen wrench (
4
– Fig.7) on the guide plate so that the notch
with the desired cutting depth is under the knife.
> Move the knife so that the cutting edge touches the Allen wrench at
the point with the desired cutting depth.
> Retighten the Allen screw of the knife.
Tightening torque: 35 Nm
EDER Contour Planer EKH-C
Sharp knives are required for optimal work with the EDER Contour
Planer EKH-C.
Blunt knives can be sharpened manually using normal grinding
wheels. Cutting edge angle is 40°.
For adjustment you need the supplied Allen wrench and the knife gauge.
On the knife gauge there are notches with which you can adjust the
knives to 0.2 mm, 0.4 mm and 0.6 mm cutting depth.
1
2
3
4
i
