Benefits
The EdenPURE® OxiLeaf® XL100 brings the most advanced air purification technology into the comfort of
your home. Unlike other air purifiers, the OxiLeaf® XL100 does more than simply filter the air in your home.
Incorporating technology like photo catalytic oxidation, high level negative ionization, scalable purification and
electrostatic filtration allows the OxiLeaf® XL100 to provide tangible benefits to your home or workspace by:
• Destroying pollution from the air, embedded in walls, ceilings, floors, carpets, furniture, etc.
• Reducing or eliminating odors such as cigarette smoke, mildew, food, etc.
• Contributing to the sanitization of all surfaces.
The whisper quiet five-speed fan disguises the power encapsulated in the advanced OxiLeaf® XL100. Having the
unit in your home will not only improve the quality of air but, most importantly, it will improve the quality of life.
Tools Required
You will need a #2 Phillips Screwdriver
Installing the PCO Cell
• Position the PCO Cell inside the unit so that the two tabs are on the bottom and interior side of the PCO Cell.
Ensure the holes in the two tabs fit over the two Screw Posts. Screw the Thumb Nuts into the Screw Posts until
they are snug.
• Align the PCO Cell Power Connector with the PCO Cell Power Connector Outlet and push gently until the
tabs at the top and bottom of the PCO Cell Power Connector snap into place, holding it in the PCO Cell Power
Connector Outlet.
Installing the Purification Plate
• Holding the Purification Plate by the ceramic, slowly insert it into the Purification Plate Slot, ensuring that the
Purification Plate is sliding into the grooves on either side.
NOTE:
About halfway in, the Purification Plate Connectors are parted. Continue sliding the Purification Plate into
the Purification Plate Slot until there is approximately one inch of the Purification Plate remaining outside the
Purification Plate Slot and significant resistance is met. Be careful not to force the Purification Plate further into
the Purification Plate Slot as this could seriously damage the unit.
Installing the Filter Assembly
• Hold the Filter Assembly with the larger flat side facing the interior of the unit. A sticker reading, “Caution:
Reinstall Filter After Cleaning” is located on the opposite side of the Filter Assembly. This sticker should be
visible when you install the Filter Assembly.
• Insert the bottom of the Filter Assembly into the tabs on the rear of the unit and then seat the Filter Assembly on
the rear of the unit. NOTE: If the Filter Assembly isn’t inserted into the tabs properly, disassembling the unit in
the future could be extremely difficult.
• Screw the two Brass Thumbscrews into their holes at the top corners of the Filter Assembly.
Installing the Rear Cover
• Place the tab at the top of the Rear Cover into the hole at the top of the Filter Assembly, then lay the Rear Cover
flat against the rear of the unit until the tabs on the sides of the Rear Cover click into place on the unit.
• Carefully insert the Rear Cover Screw into its hole on the Rear Cover (above the Power Cord Port) and tighten.
Installing the Power Cord
• Insert the Power Adaptor Plug into the rear of the unit.
• Ensure the Power Cord is properly connected to the Power Adapter.
• Insert the Power Plug into a wall outlet.
Turning the Unit On
Press the power button. Ensure that the unit’s settings are adjusted to suit the environment.
Assembly
Product Introduction
