6
Performance Suggestions
To assure maximum performance of the EdenPURE
™
Heater, please note
the following recommendations:
1) For best results, do not locate the heater in an area with a high rate of
air filtration and movement as the warm air will be exhausted.
2) Try placing the heater near a warmer inside wall and direct the output
towards a cooler outside wall. The cooler outside wall will tend to
draw the generated heat towards itself, which will allow for more effi-
cient heating.
3) Placing the heater next to a cold air return will draw the heat away
from area to be heated. Try closing or covering the cold air return.
This will allow for more efficient heating. Experiment with the place-
ment of the heater to see what works best for you.
4) To ensure maximum efficiency, a 40% minimum relative humidity
should be maintained in the heated environment.
5) The heaters are designed to operate for maximum efficiency up to 70-
72 degree range. Due to the soft heat concept, temperatures at 68
degrees feel as though it were 72 degrees. This is due to the heat mix-
ing with humidity evenly for “head-to-toe” comfort.
6) When the heater is placed in an isolated area, i.e. basement or recre-
ation area, the delivery registers and air return grills of the
existing system should be closed in that area if possible.
7) Try placing the heater a few feet above the floor in rooms with large
areas of bare concrete. Make sure the heater is secure and won’t fall.
This will allow for more efficient heating since concrete acts as a heat
sink and will tend to draw the heat its direction.
8) Try lowering your central heating system to a lower temperature and
placing the heater in the area you spend the majority of your time.
Now set the EdenPURE
™
heater to your comfort level. After all, there
is no point to heating multiple rooms to 68+ degrees when not in use.
9) When heating larger areas, place the heater in a central location. If a
ceiling fan is nearby, try using it at the same time to help distribute
the heat evenly. Our suggestion, give it a try and see what works best
for you.
10) If used in an extremely dirty or dusty area, the filter must be cleaned more
frequently as the filter can clog and cause the heater to stop working.
